Autostart Polarstart PS-3085SH Przewodnik Instalacji Pobierz pdf (Strona 10)

P. 10 Installation Guide PS-3085SH

12 YELLOW

(+) Glow-Plug

input

(cont.)

(Also known as the “wait-to-start light”.) The

purpose of the Glow-plug circuit on diesel vehicles

is to pre-heat the Combustion Chamber before the

vehicle is started.

When a Remote Starter is installed on a diesel

vehicle, the Glow-plug section of the Ignition

circuit must be activated and allowed to operate

before the vehicle is remote-started. For that

purpose, the Glow-plug input wire of the Remote

Car Starter must be connected to the Glow-plug

indicator light of the vehicle.

Caution! The Remote Car Starter will only accept

positive Glow-plug input signals, therefore

negative Glow Plugs should only be connected

using relays to invert the polarity.

A diode must be added between the negative

Glow-plug trigger on the relay and the negative

Glow-plug wire of the car. This is to prevent

feedback effects on the Glow-plug indicator light

on the instrument cluster: the light on the dash

would come on because of the feedback, even

though the circuit is off.

When the user remote-starts the vehicle:

• The Remote Car Starter will power up the

Ignition circuit and wait to engage the Starter

Motor while the Glow-plug indicator light is still

on.

• The Remote Car Starter will engage the Starter

Motor as soon as the Glow-plug light (+) goes

out.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 24 25

Brak uwag

Autostart Polarstart PS-3085SH Przewodnik Instalacji Strona 10